R22 VAN OXYGEN SENSOR FOR DIVESOFT

vandagraph r-22van oxygen sensor for divesoft: Vandagraph R-22VAN oxygen sensor, compatible with Oxyspy. NOTE: This sensor is not suitable for use with Rebreathers

R22AT OXYGEN SENSOR FOR ATA

r-22at vandagraph oxygen sensor for ata: R-22AT Vandagraph oxygen sensor compatible with: Analox ATA, Analox ATA Pro, Analox 9100-9212-94

BLACK WEIGHT POCKET 2.3 KG UNIT

High resistance cordura weight pocket for harness, with capacity for 2.3 kg ballast pads approximately. Fast closing and release clip in plastic on the outside and flap with Velcro. Ideal to place on harness webbing, tank webbing and even on belts. Stainless steel eyelet at the bottom for water drainage and rear strap to adjust to bottle buckle or harness. Sold by the unit.

BLACK TEK SHORTS WITH POCKETS

TDS bermuda shorts with pockets are perfect for use with wet suits or dry suits that do not have pockets, for an additional storage system, so necessary in technical diving, and also very useful in recreational dives.

WRIST DEPTH GAUGE 70 M

Wrist analog depth gauge up to 70 m, with maximum depth marker. Very useful in apnea or spearfishing lowered to control depth.

ACCESSORIES POCKET BLACK

Heavy duty cordura accessory holder pocket for harness or jacket, perfect for carrying small accessories and even a spare mask . Ideal to place on harness webbing, jacket and even on belts with webbing up to 50 mm.

SEIKA GPS SYSTEM FOR SUEX DPV

Suex brought the GPS signal underwater in wireless mode - SEIKA transmits the position to all ERON D-1s in the water. SEIKA uses an embedded GNSS (Global Navigation Satellite System) receiver within an SMB (Surface Marker Buoy) to capture precise diver position and communicate wireless that position to the Suex Eron D-1 dashboard.

2nd STAGE 90° REVOLVING CONNECTOR

Fixed elbow to place between the second stage and the hose, which allows routing to 90 degrees. Made of chrome plated brass. Thread 9/16 "Male to 9/16" female.

M26 OXYGEN VALVE 232 B

Valve with M25x2 thread EN144 bottle, M26x2 output with a 232 atm working pressure. Elongated green plastic knob. Especially for stage cylinders. The valves are shipped with seals and lubricants compatible for oxygen.

M25X2 VALVE 232 B BLACK

M 25x2 cylinder therad and EN144-1. Standard Yoke Outlet with a Spin-Out Threaded DIN Adapter. Matte black finish, designed for special forces that avoids glare and camouflages the diver's silhouette.

TWIN RIGHT VALVE M25 232 BAR WITHOUT CAP

Valve with M25 thread and toroidal sealing bottles (not EN144), exit DIN / INT convertible by core with a 232 atm working pressure. Black plastic knob on the right and output for connection to modular manifold.

REGULATOR NECK BAND

Elastic rubber band for fixing the emergency regulator to the neck. Easy to locate and can even keep the second stage fixed to the mouth in an emergency situation.

M25 TWIN RIGHT VALVE WO/ CAP 232 B

Valve with M25 thread and toroidal sealing bottles (not EN144), exit DIN / INT convertible by core with a 232 atm working pressure. Black plastic knob on the left and output for connection to modular manifold.

TWIN RIGHT VALVE BLACK M25 232 BAR WITHOUT CAP

Valve with M25 thread and toroidal sealing bottles (not EN144), exit DIN / INT convertible by core with a 232 atm working pressure. Black plastic knob on the right and output for connection to modular manifold. Matte black finish, designed for special forces that avoids glare and camouflages the diver's silhouette.

ON/OFF REGULATOR VALVE LONG FLOWSTOP

On / off valve that opens or closes the air flow into the hose line where it is installed. It can be installed on any standard LP regulator hose. Approximate length: 7.8 cm